build platform · FF-0593

Would Steve change anything on the ARDUN after the dyno test?

Nothing comes to mind, though he may need time to reflect. He had the benefit of Don Ferguson, who makes the heads, being there, and had talked with Don over almost three years about every question, so the engine was set up more or less the way Don recommended, including the timing. Steve thinks Don has enough experience to know where these need to be, and they really did not have to mess with it at all.

Expert

Steve Coppock

Evidence

expert attributed

Component

engine setup

Applicable scope

Ford Flathead V8 with Don Ferguson reproduction ARDUN overhead valve heads, Steve Coppock's engine of about 289 cubic inches, single four barrel, on the dyno at Klein Engines